Thread Rating:
  • 283 Vote(s) - 3.08 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Frog - ZA3: gates won't open
#1
I've installed the Came frog series gates and they won't open.
I've no wire connected to the controller pcb only shorted pins 1->2 and 2->C1
and then I briefly short pin 2 to pin 3 to try and open the gates. The relays start clicking but the gates don't move. The gates close properly by shorting pins 2->4. I have swapped the motor wiring and shorted 2->4 and the gates open so this looks like a pcb issue. Has anyone else seen this? Any ideas how to debug the issue?
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Came FROG - one leaf occasionally does not open fezster 3 543 03-08-2021, 10:07 AM
Last Post: JamieF
  Came Gates - power cut issues Paddy_SP 2 753 22-07-2021, 09:42 AM
Last Post: Paddy_SP
  Came Double Swing Gates opens by itself for some centimeters risp73 0 5,322 19-06-2020, 06:19 PM
Last Post: risp73
  Came gates Ring8180 1 56,385 10-07-2019, 10:39 AM
Last Post: JoeF
  CAME ZLJ24 panel - Open gate indicator-light Domcov 1 11,296 02-05-2018, 06:18 PM
Last Post: Automatic-TC
  Came ZM3E and Frog Motors both opening on M1 not seperately giuseppem 1 9,687 11-04-2018, 07:25 AM
Last Post: Automatic-TC
  Gates out of sync frankjboyd 1 9,829 07-01-2018, 03:25 PM
Last Post: Automatic-TC
  Frog p 230v or 24v ? Emilyjudy 5 25,080 08-03-2014, 01:32 AM
Last Post: stephen70
  CAME Frog and Daitem 902 jderuk 1 10,467 08-03-2014, 01:17 AM
Last Post: stephen70
  CAME double gates - one side closes but will not open crliving 1 11,872 02-08-2013, 09:39 AM
Last Post: Blakey111

Forum Jump:


Users browsing this thread: 1 Guest(s)