| Online Users |
There are currently 43 online users.
» 0 Member(s) | 43 Guest(s)
|
| Latest Threads |
Help programming SUN 433 ...
Forum: Automatic Gates - Help and Support
Last Post: TerryMulhern
Yesterday, 09:54 AM
» Replies: 1
» Views: 200
|
Swing Gate arm not moving...
Forum: General Discussions
Last Post: Stacker
13-02-2019, 02:55 PM
» Replies: 3
» Views: 349
|
Access Control Profession...
Forum: General Discussions
Last Post: Lowvoltagesupply
07-02-2019, 11:56 PM
» Replies: 0
» Views: 137
|
Faac 455D opening/closing...
Forum: FAAC Gate Openers
Last Post: Niko
04-02-2019, 01:49 PM
» Replies: 0
» Views: 141
|
Faac 455D opening/closing...
Forum: FAAC Gate Openers
Last Post: Niko
03-02-2019, 11:44 PM
» Replies: 0
» Views: 78
|
BFT Urano ground loop
Forum: BFT Automatic Gate Openers
Last Post: muturola123
31-01-2019, 11:36 AM
» Replies: 0
» Views: 141
|
Genius Euro Bat 300 SX - ...
Forum: General Discussions
Last Post: rossflight
29-01-2019, 05:12 PM
» Replies: 0
» Views: 105
|
BFT Gate Opener not closi...
Forum: BFT Automatic Gate Openers
Last Post: Anay
24-01-2019, 12:05 PM
» Replies: 0
» Views: 217
|
LYN300K
Forum: Liftmaster Gate Openers
Last Post: Richard B
21-01-2019, 11:14 AM
» Replies: 0
» Views: 207
|
V2 Phox 2-Channel Remote ...
Forum: Automatic Gates - Help and Support
Last Post: moldy1
20-01-2019, 01:41 PM
» Replies: 0
» Views: 232
|
|
|
| remote controls for CLEMSA CLAS 12 |
|
Posted by: - 26-09-2009, 04:54 PM - Forum: Gate Automation and Installation Help
- No Replies
|
 |
Hi to you all,
I am currently living in Spain and i have automatic gates with no remote control units. The control unit is CLEMSA CLAS 12 with RMV receiver, i have obtained new MASTERCODE MV1 transmitter but cannot activate it does anyone have any ideas?
|
|
|
| Open / Close limits won't set on CB24 |
|
Posted by: - 17-04-2009, 11:49 AM - Forum: Gate Automation and Installation Help
- Replies (1)
|
|
Opened my gates and they went past the normal open limit setting. I now can't seem to reset the open/close limits on my gates - i go through the instructions setting open limit, press button and set close limit press button again but the open limit led starts flashing again. I've tried this several times and on each occassion the open limit led starts flashing again after setting the close limit... anyone know what the problem could be?
|
|
|
|
|
