Thread Rating:
  • 282 Vote(s) - 3.08 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Frog - ZA3: gates won't open
#1
I've installed the Came frog series gates and they won't open.
I've no wire connected to the controller pcb only shorted pins 1->2 and 2->C1
and then I briefly short pin 2 to pin 3 to try and open the gates. The relays start clicking but the gates don't move. The gates close properly by shorting pins 2->4. I have swapped the motor wiring and shorted 2->4 and the gates open so this looks like a pcb issue. Has anyone else seen this? Any ideas how to debug the issue?
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Came Double Swing Gates opens by itself for some centimeters risp73 0 1,735 19-06-2020, 06:19 PM
Last Post: risp73
  Came gates Ring8180 1 37,702 10-07-2019, 10:39 AM
Last Post: JoeF
  CAME ZLJ24 panel - Open gate indicator-light Domcov 1 6,623 02-05-2018, 06:18 PM
Last Post: Automatic-TC
  Came ZM3E and Frog Motors both opening on M1 not seperately giuseppem 1 5,021 11-04-2018, 07:25 AM
Last Post: Automatic-TC
  Gates out of sync frankjboyd 1 7,554 07-01-2018, 03:25 PM
Last Post: Automatic-TC
  Frog p 230v or 24v ? Emilyjudy 5 20,611 08-03-2014, 01:32 AM
Last Post: stephen70
  CAME Frog and Daitem 902 jderuk 1 7,666 08-03-2014, 01:17 AM
Last Post: stephen70
  CAME double gates - one side closes but will not open crliving 1 9,272 02-08-2013, 09:39 AM
Last Post: Blakey111
Rolleyes 400 Newton limit on boarded gates Paul smith 3 14,258 12-01-2012, 11:20 AM
Last Post: sebabastek
  CAME Ati A3000A - Will not open 2 11,024 12-07-2010, 09:43 PM
Last Post: Guest

Forum Jump:


Users browsing this thread: 1 Guest(s)