Thread Rating:
  • 173 Vote(s) - 2.92 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gates out of sync
#6
(03-01-2023, 04:14 PM)Murphe5 Wrote:
(31-12-2022, 01:31 PM)Murphe5 Wrote: Hi All,
I have the same issue with my Came system where one game opens when the other closes.
One of the motors was replaced last week but is out of sync
The board is a za3
Has anyone seen this issue before?

Issue resolved, I switched the polarity on the new motor. Working good now.

Hi,

Great to hear Smile

Sam.
EasyGates.co.uk - EasyGates Ltd
 
EasyGates Direct - Trade only accounts.

Smart and Secure Center - Smart Home Products
Reply


Messages In This Thread
Gates out of sync - by frankjboyd - 07-01-2018, 10:38 AM
RE: Gates out of sync - by Automatic-TC - 07-01-2018, 03:25 PM
RE: Gates out of sync - by Murphe5 - 31-12-2022, 01:28 PM
RE: Gates out of sync - by Murphe5 - 31-12-2022, 01:31 PM
RE: Gates out of sync - by Murphe5 - 03-01-2023, 04:14 PM
RE: Gates out of sync - by SamA - 05-01-2023, 11:52 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Came FROG-A + ZA3 controller > gates wont close safety beam endam 6 7,752 23-02-2023, 01:09 PM
Last Post: SamA
  Came Gates Error code E14 janker 3 5,666 14-11-2022, 11:59 AM
Last Post: benbrooks
  My Came ZM3E gates won’t open golfnut75 1 5,133 12-08-2022, 08:40 AM
Last Post: SamA
  ZA3 Came gates not opening with RF device chooper 5 7,209 24-06-2022, 08:58 AM
Last Post: JoeF
  Came Gates - power cut issues Paddy_SP 2 7,099 22-07-2021, 09:42 AM
Last Post: Paddy_SP
  Came Double Swing Gates opens by itself for some centimeters risp73 0 8,613 19-06-2020, 06:19 PM
Last Post: risp73
  Came gates Ring8180 1 79,975 10-07-2019, 10:39 AM
Last Post: JoeF
  Frog - ZA3: gates won't open BarryD 0 10,212 15-06-2016, 01:34 PM
Last Post: BarryD
  CAME double gates - one side closes but will not open crliving 1 17,286 02-08-2013, 09:39 AM
Last Post: Blakey111
Rolleyes 400 Newton limit on boarded gates Paul smith 3 21,715 12-01-2012, 11:20 AM
Last Post: sebabastek

Forum Jump:


Users browsing this thread: 1 Guest(s)