Thread Rating:
  • 151 Vote(s) - 3.2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Q60A/R error. Showing "_ "
#5
Thank you for the manual.. i already got it, and none of the central error messages are described on the manual. I'm not able to do any programming, as a reset.
I already disconnected everything, and nothing changes...

I was wondering if there is a way to force the central to a reset...

Bests,


(03-11-2017, 07:58 AM)Automatic-TC Wrote:
(03-11-2017, 05:13 AM)Jonas Pistolas Wrote: The 5A fuse was the one that had blow up.

I already dried everything very well, but with no sucess.. ?
hi
http://manuals.easygates.co.uk/PDF/misc/mygate.pdf

you should check all accessories photo,receiver etc ...... with manual you can try to programing once again ..
Reply


Messages In This Thread
Q60A/R error. Showing "_ " - by Jonas Pistolas - 02-11-2017, 08:25 PM
RE: Q60A/R error. Showing "_ " - by Automatic-TC - 02-11-2017, 09:44 PM
RE: Q60A/R error. Showing "_ " - by Automatic-TC - 03-11-2017, 07:58 AM
RE: Q60A/R error. Showing "_ " - by Jonas Pistolas - 03-11-2017, 10:19 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Proteco Advantage (Q60A) Error Code "03" CLAUDIOTX 3 18,016 26-09-2023, 05:32 AM
Last Post: max666
Exclamation Proteco Q60A stopped working xCO 0 981 19-06-2023, 01:03 PM
Last Post: xCO
  Replacement Q60A board? ndyhzlwd 1 1,935 10-02-2023, 03:19 PM
Last Post: SamA
  Hello - Another Proteco Q60A/R Question! SawboMan 2 3,154 12-07-2022, 11:48 AM
Last Post: SamA
  Proteco Q60 - FH error then close after opening Needlerp 1 2,393 24-06-2022, 09:54 AM
Last Post: JamieF
  proteco q60a microcontroller program arashkhan 1 2,608 17-06-2022, 01:29 PM
Last Post: benbrooks
  Thalia P - BAR error devsolo 2 9,549 07-01-2021, 04:05 PM
Last Post: GilbertoMoncada
  Deimos BT 400/600 error codes orange 0 3,920 07-12-2020, 09:36 AM
Last Post: orange
  Fav sliding gate error code plus other Adam67 0 9,032 02-09-2020, 07:06 PM
Last Post: Adam67
  Re: Error 30 tony.jay8 2 11,117 10-05-2018, 11:17 PM
Last Post: tony.jay8

Forum Jump:


Users browsing this thread: 1 Guest(s)