Thread Rating:
  • 5 Vote(s) - 2.6 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Broken bft gates
Hi all,

I am new to this site, so please be kind

This morning my bft swing gates opened fine, but now they will not move!

I have read other posts and the display in the main box says phot

When I press the open button the display changes from phot to strt then straight back to phot

I have cleaned the 4 sensors inside and out and am at a loss

Any ideas would be greatly appreciated

Many thanks


i would recommend removing all cells and running short leads from the cells directly to the panel.

this most likely will be a short on the cable causing the cells to go open circuit.

if not possible please bell out the cables for a continuity check.
“Phot”is a fault on safety circuit. I’d check each set of beams, one side of each set of beam should be clicking as you cover/uncover. If neither on 1 set are clicking you likely have some faulty beams. Check phot PCBs for corrosion/insects.. they may have blown your accessories fuse. Do you have any lights on any of them?

Possibly Related Threads…
Thread Author Replies Views Last Post
  Rigel 5 , gates won't open Nameloc 0 196 25-05-2020, 10:50 AM
Last Post: Nameloc
  Faac 770 455D Gates Auto closing framsbottom 6 4,663 23-04-2020, 08:56 AM
Last Post: framsbottom
  Cost of holding gates open Helen 1 1,578 22-04-2020, 10:59 PM
Last Post: Luke Scott
  Gates TRIPPING rcd with internal open/close switch. bomitie 5 45,984 06-12-2019, 11:10 AM
Last Post: JoeF
  Gate Controls/Indicators 200m from Gates ADickson 10 24,045 20-06-2019, 06:32 PM
Last Post: RogerSlaughter
  Came Gates Nod 0 2,076 11-01-2019, 08:53 PM
Last Post: Nod
  Came gates za3p Webby 1 3,873 03-08-2018, 08:42 PM
Last Post: Automatic-TC
  Came gates stuck open. Ring8180 1 6,049 07-05-2018, 11:31 AM
Last Post: Automatic-TC
  Car ran into set of gates with FAAC S700 Operators orbital1234 1 4,189 30-04-2018, 01:50 PM
Last Post: Tim
  Help!!!! GSM intercom how do you open gates!? Missfern 2 5,955 11-10-2017, 03:08 PM
Last Post: Access-Control-Ltd

Forum Jump:

Users browsing this thread: 1 Guest(s)