Thread Rating:
  • 49 Vote(s) - 2.86 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Came gates za3p
#1
Hi.  New here.  I have just installed my new gates   The program is flashing on pcb board   I have fitted radio frequency board  but I don’t have any photo cells how do I short out them ? Thanks in advance
Reply
#2
hi

2-1 / 2-c1/ 2-cx /
there are three NC contact bridge them up
Best Regards 
Tom 
Automatic-TC
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Gate Controls/Indicators 200m from Gates ADickson 5 7,271 17-10-2018, 07:33 PM
Last Post: alleno
  Came gates stuck open. Ring8180 1 1,728 07-05-2018, 11:31 AM
Last Post: Automatic-TC
  Gates TRIPPING rcd with internal open/close switch. bomitie 3 1,749 04-05-2018, 06:26 PM
Last Post: bomitie
  Car ran into set of gates with FAAC S700 Operators orbital1234 1 1,243 30-04-2018, 01:50 PM
Last Post: Tim
  Help!!!! GSM intercom how do you open gates!? Missfern 2 2,276 11-10-2017, 03:08 PM
Last Post: Access-Control-Ltd
  stabalising gates ian777 1 1,799 15-09-2017, 10:08 AM
Last Post: Sav
  Q36A Proteco Gates dunkmat 0 1,983 06-09-2017, 04:56 PM
Last Post: dunkmat
  lady needing help with electric gates please debslife 3 3,526 26-04-2017, 09:26 PM
Last Post: Automatic-TC
  Gates Opening After Closing tht7 0 1,890 15-04-2017, 07:39 PM
Last Post: tht7
  Proteco Leader Swing gates Adam 2 3,281 10-12-2016, 12:57 AM
Last Post: Automatic-TC

Forum Jump:


Users browsing this thread: 1 Guest(s)