Thread Rating:
  • 3 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CAME ZM3E
#1
Hi,

I have a FROG motor installation with 2x swing gates.
In place working well for 7 yrs (except for slugs taking out 2 x pcb boards)

Today, one side will not close. It attempts to close but then stops and goes back to fully open.
Even when I run the encoder test, the same thing happens (M1 opens fully and M2 tries to close and stops after a few inches of travel.

I only have photocells as a safety input device.

Any thoughts to the problem here?

Thank you,

Mike
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Came ZM3E and Frog Motors both opening on M1 not seperately giuseppem 1 5,768 11-04-2018, 07:25 AM
Last Post: Automatic-TC

Forum Jump:


Users browsing this thread: 1 Guest(s)