Thread Rating:
  • 72 Vote(s) - 2.89 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Came gates za3p
#1
Hi.  New here.  I have just installed my new gates   The program is flashing on pcb board   I have fitted radio frequency board  but I don’t have any photo cells how do I short out them ? Thanks in advance
Reply
#2
hi

2-1 / 2-c1/ 2-cx /
there are three NC contact bridge them up
Best Regards 
Tom 
Automatic-TC
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Rigel 5 , gates won't open Nameloc 0 104 25-05-2020, 10:50 AM
Last Post: Nameloc
  Faac 770 455D Gates Auto closing framsbottom 6 4,631 23-04-2020, 08:56 AM
Last Post: framsbottom
  Cost of holding gates open Helen 1 1,567 22-04-2020, 10:59 PM
Last Post: Luke Scott
  Broken bft gates Chrisbftbroken 2 1,593 22-04-2020, 10:47 PM
Last Post: Luke Scott
  Gates TRIPPING rcd with internal open/close switch. bomitie 5 45,953 06-12-2019, 11:10 AM
Last Post: JoeF
  Gate Controls/Indicators 200m from Gates ADickson 10 24,009 20-06-2019, 06:32 PM
Last Post: RogerSlaughter
  Came Gates Nod 0 2,066 11-01-2019, 08:53 PM
Last Post: Nod
  Came gates stuck open. Ring8180 1 6,043 07-05-2018, 11:31 AM
Last Post: Automatic-TC
  Car ran into set of gates with FAAC S700 Operators orbital1234 1 4,178 30-04-2018, 01:50 PM
Last Post: Tim
  Help!!!! GSM intercom how do you open gates!? Missfern 2 5,946 11-10-2017, 03:08 PM
Last Post: Access-Control-Ltd

Forum Jump:


Users browsing this thread: 1 Guest(s)