Thread Rating:
  • 265 Vote(s) - 2.81 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Proteco Leader rams very slow
#1
Hi to everyone here

I have Proteco Leader rams on my wooden gates (inward opening) and I have noticed them starting off normally but then about half way through they slow right down, and now now that winter is here they virtually stop 2/3rds of the way through the closing cycle.

They open OK, it's just closing.

I suspect that they need greasing/oiling, but I am not sure where to put and what oil to use internally. Any advice would be much appreciated.

David
Reply


Messages In This Thread
Proteco Leader rams very slow - by drshemmming - 04-11-2012, 02:29 PM
RE: Proteco Leader rams very slow - by Mark - 05-11-2012, 12:34 PM
RE: Proteco Leader rams very slow - by scoobydoc - 07-11-2012, 10:29 PM
RE: Proteco Leader rams very slow - by Proteco_UK - 15-11-2012, 11:29 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Proteco Advantage (Q60A) Error Code "03" CLAUDIOTX 3 18,058 26-09-2023, 05:32 AM
Last Post: max666
Exclamation Proteco Q60A stopped working xCO 0 984 19-06-2023, 01:03 PM
Last Post: xCO
  Proteco controller & ACT5e keypad - keeps tripping fclauson 4 4,042 26-08-2022, 03:42 PM
Last Post: JoeF
  Hello - Another Proteco Q60A/R Question! SawboMan 2 3,180 12-07-2022, 11:48 AM
Last Post: SamA
  Proteco Q60 - FH error then close after opening Needlerp 1 2,409 24-06-2022, 09:54 AM
Last Post: JamieF
  proteco q60a microcontroller program arashkhan 1 2,624 17-06-2022, 01:29 PM
Last Post: benbrooks
  Proteco Q60 AR ...Fob wont program Shane1 0 1,752 12-01-2022, 08:13 PM
Last Post: Shane1
  Proteco Leader N1 problem Luc Bevers 0 2,075 22-10-2021, 09:57 AM
Last Post: Luc Bevers
  Proteco gates with photocell problem. Shane1 0 2,197 09-10-2021, 07:56 PM
Last Post: Shane1
  Proteco Aster 3 ram fault soother 2 5,025 14-07-2021, 11:58 PM
Last Post: soother

Forum Jump:


Users browsing this thread: 2 Guest(s)