Q60AR Problem
|
Q60AR Problem
|
|
17-07-2014, 03:02 PM
I have an electric gate using the Q60 processor. It all works fine BUT when closing the final thrust of the motor is excessive. It is apparently adjustable on parameter R1 however, when scrolling through the parameter menu it skips the R1. Is there a special way to access this for adjustment?
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Photocell Problem | marcoos_1 | 4 | 26,399 |
04-01-2024, 10:23 AM Last Post: JoeF |
|
| TC fault code on Q60ar control board | Skydive1710 | 3 | 8,359 |
20-11-2023, 03:12 PM Last Post: NormanY |
|
| Master to slave remote problem | Dingerb | 0 | 3,165 |
24-12-2021, 01:26 PM Last Post: Dingerb |
|
| Proteco Leader N1 problem | Luc Bevers | 0 | 3,624 |
22-10-2021, 09:57 AM Last Post: Luc Bevers |
|
| Proteco gates with photocell problem. | Shane1 | 0 | 3,568 |
09-10-2021, 07:56 PM Last Post: Shane1 |
|
| BFT ULTRA BT A50 problem | cayres | 0 | 3,576 |
13-04-2021, 08:19 AM Last Post: cayres |
|
| Beninca RI 6E Problem | leonardermo | 0 | 5,860 |
29-04-2020, 08:45 PM Last Post: leonardermo |
|
| Genius Gate System Problem | grasshopper | 1 | 13,918 |
01-07-2019, 09:39 AM Last Post: JoeF |
|
| Genius JA574 problem | jeeter | 0 | 6,140 |
02-05-2019, 01:13 PM Last Post: jeeter |
|
| CB124EV Problem | biker-boss | 1 | 10,715 |
11-10-2017, 07:19 AM Last Post: Automatic-TC |
|
