Thread Rating:
  • 2 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Liftmaster scs
#1
Hi I have a new set of liftmaster scs 324. For some reason I cannot get them to learn the programming for the opening distance. I can get to the point where I open them where I need them
To but they dnt close in the in the final part of the learn mode.  the dgn light is always falshing between 5 lights and 3 lights. 

Thanks
Reply
#2
(20-10-2020, 08:56 AM)Athers Wrote: Hi I have a new set of liftmaster scs 324. For some reason I cannot get them to learn the programming for the opening distance. I can get to the point where I open them where I need them
To but they dnt close in the in the final part of the learn mode.  the dgn light is always falshing between 5 lights and 3 lights. 

Thanks

Hi,

The 3 flashes indicate a wiring issue or poor connection to the control panel on motor 2. This is usually due to the coloured encoder cables being put into the wrong terminals. It can also be caused by a poor joint in the cabling if the cable crosses the road.

If you are using a single motor system you must set the DIP switch 1/2 motor to on. Otherwise the control panel will be trying to detect the second motor which is not installed.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Liftmaster scs Athers 0 1,074 19-10-2020, 08:08 PM
Last Post: Athers
  Liftmaster LYN300K, 400K zappahead 1 8,622 12-04-2018, 03:30 PM
Last Post: Tim
  Wanted - Liftmaster SUB300M Motor pigsfoot 1 9,164 03-06-2015, 04:07 PM
Last Post: Sav
  >> Liftmaster CB11 Support Diagrams << easygates 1 16,601 27-04-2009, 12:49 PM
Last Post: easygates
  >> Liftmaster CB24 Support Diagrams << easygates 3 19,124 27-04-2009, 10:58 AM
Last Post: easygates
  >>> Liftmaster CB24 Simple Setup Guide <<< easygates 0 9,680 30-03-2009, 04:27 PM
Last Post: easygates

Forum Jump:


Users browsing this thread: 1 Guest(s)