Thread Rating:
  • 8 Vote(s) - 2.63 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Nice Remote - Lock out
#1
Hi, I was attempting to programme a clone remote as my wife's On2 has been broken by her long fingernails!

Last time I did this I was successful, but this time I appear to have stopped my only working gate opener from working.

The light is flashing on the remote. The gate simply is not moving. The motor and everything is working fine when button pressed on the motor unit.

I have done a lock out before  - though I am not sure how I did it.


The gate engineer said there is a "holiday" mode - whereby you press a button on the remote, it will prevent it being opened until re-enabled. Appparently this is a security feature? However, it appears to be undocumented in the manuals.

Can anyone advise me how to get it out of this useless state and re-enable it? The On2 has two buttons, it is a robus 350 I believe.

Thanks

Roger
Reply
#2
Hi,

If you have an OView programming control unit.

Go into your settings and then commands and then unblock and close.

Kindest Regards,

Sam.
EasyGates.co.uk - EasyGates Ltd
 
EasyGates Direct - Trade only accounts.

Smart and Secure Center - Smart Home Products
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  nice robus D400 smartphone control YOSH 1 525 05-03-2024, 04:45 PM
Last Post: benbrooks
  Nice MC800 Wiring issue Adamzsite 2 550 05-03-2024, 04:37 PM
Last Post: Michael
  nice robus troubleshooting tarmongaidon 7 16,109 30-01-2024, 05:19 PM
Last Post: hasanova
  Nice photo sensor issue F210 and MC824H gates won’t operate Tantrum 1 1,522 04-01-2024, 10:06 AM
Last Post: Michael
  Nice Robus RBA3c Wifi Relay Switch Wiring denis 1 2,004 01-11-2023, 09:45 AM
Last Post: Michael
  NICE MC800 Factory Reset bg148 5 2,883 12-10-2023, 01:11 PM
Last Post: JoeF
  Nice MCA1 stuck open after stop command Khooke 1 2,328 25-09-2023, 10:47 AM
Last Post: Michael
  Nice transmitters - compatibility Noghar 6 6,590 10-10-2022, 10:02 AM
Last Post: benbrooks
  NICE MC82H - connecting maglock grangerd 3 4,833 10-10-2022, 09:40 AM
Last Post: SamA
  Nice Robus Don't Auto Close!!!! Ali_1982 1 4,301 03-08-2022, 02:23 PM
Last Post: Michael

Forum Jump:


Users browsing this thread: 1 Guest(s)