Thread Rating:
  • 22 Vote(s) - 2.64 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Allmatic Automation big 2.2
Hi new to this but I have been working on and turned of a allmatic big 2.2 sliding gate motor. Can't get it to comply the gate has full safety edges fitted but the gate just stops and dose not return. I can program the gate to stop and return in the close direction but it says in the manual that it will not work in the open. The people who fitted the gate had wired the edges in to the stop circuit insted of the terminals for the edge. Don't know if anyone has worked on one of these and can advise. Thank in advanceĀ  Big Grin

Possibly Related Threads…
Thread Author Replies Views Last Post
  Reccomendation: side gate automation GeorgieB1 1 3,916 19-09-2018, 06:49 PM
Last Post: Automatic-TC
  Legal requirements for gate automation installations 6 21,657 18-05-2010, 05:24 PM
Last Post: easygates
  Gate automation failure/ replacement 3 13,238 15-04-2010, 02:01 PM
Last Post: easygates

Forum Jump:

Users browsing this thread: 1 Guest(s)