Thread Rating:
- 374 Vote(s) - 2.76 Average
- 1
- 2
- 3
- 4
- 5
|
Fitting set of beams to control gates
|
(19-05-2010, 04:16 PM)easygates Wrote: hi, that is a problem alot of people come across with alot of control boards. a way that might do it is if you wire a switch or somthing similar (like a latching keyswitch or latching keypad) to the start circuit then the gates should stay open when you press the switch.
Basicly if you keep the start circuit closed then the gates should stay open.
So even if you put a box over one of the beams they should stay open.
There is always your release key to use to keep them open if all else fails.
Regards
|
| Messages In This Thread |
|
RE: Fitting set of beams to control gates - by DaveC. - 14-06-2010, 10:43 PM
|
| Possibly Related Threads… |
| Thread |
Author |
Replies |
Views |
Last Post |
| |
Gates tripped |
Phil.c |
3 |
281 |
Yesterday, 09:34 AM
Last Post: Phil.c
|
| |
Rigel 5 , gates won't open |
Nameloc |
2 |
3,825 |
23-04-2024, 08:35 AM
Last Post: JoeF
|
| |
Fried control board |
nickfr |
3 |
573 |
22-03-2024, 12:53 PM
Last Post: JoeF
|
| |
Came ZA3 gates stuck open |
Ivorwindybottom |
0 |
401 |
18-02-2024, 06:29 PM
Last Post: Ivorwindybottom
|
| |
Computer controlled control panel |
dsbhachu1 |
0 |
281 |
18-02-2024, 11:35 AM
Last Post: dsbhachu1
|
| |
Electric Gates with AllMatic BIOS2 Unit |
antsnaith |
3 |
1,671 |
31-01-2024, 08:22 AM
Last Post: patronsecurity
|
| |
Came gates za3p |
Webby |
4 |
8,993 |
07-01-2024, 07:11 PM
Last Post: Simon NW
|
| |
TC fault code on Q60ar control board |
Skydive1710 |
3 |
3,594 |
20-11-2023, 03:12 PM
Last Post: NormanY
|
| |
Nice Gates not closing |
StuL |
1 |
1,618 |
24-08-2023, 01:34 PM
Last Post: JoeF
|
| |
Gates Opening After Closing |
tht7 |
2 |
9,686 |
30-07-2023, 12:30 PM
Last Post: lcpbarbosa
|
Users browsing this thread: 1 Guest(s)
