Thread Rating:
  • 9 Vote(s) - 2.78 Average
  • 1
  • 2
  • 3
  • 4
  • 5
water damage to FAAC photocell
#4
It worked, I installed the new photocell but notice the Rx end has one light only, so went back and opened the photocell and found the two of the four cables rubber casing were damaged with wires broken 10 cm from the end inside the metal post.  Luckily there was plenty of cable length, so  cut off the damaged section and connected fresh end of cables and all is good.  Thank you JoeF! Smile
Reply


Messages In This Thread
water damage to FAAC photocell - by Rajab - 11-07-2022, 04:21 PM
RE: water damage to FAAC photocell - by JoeF - 12-07-2022, 11:38 AM
RE: water damage to FAAC photocell - by Rajab - 12-07-2022, 01:39 PM
RE: water damage to FAAC photocell - by Rajab - 17-07-2022, 08:15 PM
RE: water damage to FAAC photocell - by Michael - 18-07-2022, 09:00 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  FAAc xp20d wiring Neil Young 4 3,172 04-02-2025, 12:08 PM
Last Post: Neil Young
  FAAC gates out of sync TheDock 1 2,185 21-08-2024, 12:21 PM
Last Post: TheDock
  Faac 452 pcb board benner91 2 5,032 09-02-2024, 06:13 PM
Last Post: benner91
  Faac photocell stopped working Zeb Gulickx 2 5,701 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  Photocell Problem marcoos_1 4 25,289 04-01-2024, 10:23 AM
Last Post: JoeF
  FAAC E124 fault 05 allan@amtas.com.au 0 2,568 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 7,550 03-07-2023, 08:54 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 3,154 23-06-2023, 03:19 PM
Last Post: Alpin
  FAAC Photocells mmc1977 3 6,215 02-05-2023, 12:37 PM
Last Post: Matt Turner
  Proteco gates with photocell problem. Shane1 0 3,317 09-10-2021, 07:56 PM
Last Post: Shane1

Forum Jump:


Users browsing this thread: 1 Guest(s)