Electric Gates, Garage Door, Access Control, Smart Home & Security Forums › Gate Automation and Installation Help › Nice Gate Openers v
NIce Aria 400 unable to program gate open/close

Thread Rating:
  • 24 Vote(s) - 2.75 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
NIce Aria 400 unable to program gate open/close
Telboy Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Jan 2020
Reputation: 0
#3
13-01-2020, 03:33 PM
Contacted Technical help at EasyGates and very helpful as usual. Since I only have one gate opener I was advised to wire motor into M2 terminals. Once I had done this all worked OK. The manual is not clear on this so I'd like to think it wasn't me!! There are a lot of errors in the manual so be warned, for example, on page 9 (English) fig 21 shows P1 key being pressed when I think it should be P3.
Find
Reply


Messages In This Thread
RE: NIce Aria 400 unable to program gate open/close - by Telboy - 13-01-2020, 03:33 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Youtube gate specialist broke my module Harvie C 1 494 28-10-2025, 09:40 AM
Last Post: Mohinder02
  Nice Robus closing after photo Nexur 1 6,522 26-08-2025, 01:47 PM
Last Post: Jakedugmore
  Nice LFAB occasionally failing open DaveHG 3 8,649 20-08-2025, 01:52 PM
Last Post: Jakedugmore
  Nice gates don’t close after the ambient temp is high Howard 2 7,238 15-08-2025, 02:01 PM
Last Post: Jakedugmore
  Nice Control unit passcode removal Andruelectricgates 1 2,970 17-06-2025, 11:25 AM
Last Post: HarrisonN
  NICE gates open slightly then stuck Overthefence 2 3,482 21-05-2025, 10:54 AM
Last Post: Jakedugmore
  Nice Robus 250 HS Fuse Problem GLM 1 3,687 09-05-2025, 01:07 PM
Last Post: Aiden Mitton
  Mag-lock not activating after close benkay 4 8,575 13-03-2025, 04:19 PM
Last Post: ldkerlukeHome
  Looking for help with oldschool NICE gate motor gatekeeper 0 4,240 16-02-2025, 05:16 PM
Last Post: gatekeeper
  Diagnosing Nice SFAB2024 (ex XME2024) Motors devlinjayse 0 2,871 08-02-2025, 07:22 PM
Last Post: devlinjayse

Forum Jump:


Users browsing this thread: 1 Guest(s)