Thread Rating:
  • 185 Vote(s) - 3.16 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connections for pulse
#1
I am new to this forum and I am looking for advice on the above
Dear sir
We are using 2x Elka Schranken Sentinal and 2 x Daspi Eltra 400 barriers that are currently triggered to open via a RFID card reader.

We have now installed an Automatic Number Plate Reader camera system which outputs a 24v pulse to trigger the opening when a valid number plate is read.

Please can you advise where this pulse wires need to be connected
Regards
Steve Shore
+97150 4576736
Reply
#2
(25-02-2017, 08:01 AM)STEVESHORE Wrote: I am new to this forum and I am looking for advice on the above
Dear sir
We are using 2x Elka Schranken Sentinal and 2 x Daspi Eltra 400 barriers that are currently triggered to open via a RFID card reader.

We have now installed an Automatic Number Plate Reader camera system which outputs a 24v pulse to trigger the opening when a valid number plate is read.

Please can you advise where this pulse wires need to be connected
Regards
Steve Shore
+97150 4576736

hi

you want disconect card reader and install instead of it camera plate reader?
or you want use both of them ?
Best RegardsĀ 
TomĀ 
Automatic-TC
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)