Electric Gates, Garage Door, Access Control, Smart Home & Security Forums

Full Version: Connections for pulse
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

STEVESHORE

I am new to this forum and I am looking for advice on the above
Dear sir
We are using 2x Elka Schranken Sentinal and 2 x Daspi Eltra 400 barriers that are currently triggered to open via a RFID card reader.

We have now installed an Automatic Number Plate Reader camera system which outputs a 24v pulse to trigger the opening when a valid number plate is read.

Please can you advise where this pulse wires need to be connected
Regards
Steve Shore
+97150 4576736
(25-02-2017, 08:01 AM)STEVESHORE Wrote: [ -> ]I am new to this forum and I am looking for advice on the above
Dear sir
We are using 2x Elka Schranken Sentinal and 2 x Daspi Eltra 400 barriers that are currently triggered to open via a RFID card reader.

We have now installed an Automatic Number Plate Reader camera system which outputs a 24v pulse to trigger the opening when a valid number plate is read.

Please can you advise where this pulse wires need to be connected
Regards
Steve Shore
+97150 4576736

hi

you want disconect card reader and install instead of it camera plate reader?
or you want use both of them ?