Thread Rating:
  • 233 Vote(s) - 2.64 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Roger Receiver programming
#1
Hi
On my receiver circuit I see component marked Roger R70/2AC.
I cannot easily identify the programming buttons.
There is a small board at right angles to the main circuit but because of bushes it is difficult to see if the buttons are located on that board.
What size are they likely to be?
Best regards
Reply
#2
hi there! On Roger Receiver there are two buttons size about 15X15 mm above LED.
There are several models of Roger receiver so you must know the right procedure for programing.
Unfortunately , I don't remember the procedure for this model... hope this will help you..
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  BFT DEIMOS BT Programming issue dawoodejaz@hotmail.com 0 4,787 28-11-2019, 12:11 AM
Last Post: dawoodejaz@hotmail.com
  Help programming SUN 433 4CH remote jedimatafez 2 8,859 24-02-2019, 08:04 AM
Last Post: jedimatafez
  Programming remote Luke 1 8,813 16-05-2018, 07:38 PM
Last Post: Automatic-TC
  Daspi Programming trini_tech 1 11,413 25-06-2015, 09:13 AM
Last Post: thm
  Tousek st 50 programming alban gates 1 10,495 20-10-2011, 11:22 AM
Last Post: Mark

Forum Jump:


Users browsing this thread: 1 Guest(s)