16-06-2019, 04:26 PM
Hello,
I was wondering if anyone would be able to help me troubleshoot my gate.
I have a Telescopic gate with a BFT Leo controller, bircher safety edges (RF2.2), and BFT photocells. The gate recently stopped working and was reset. I have checked all the photocells and they seem to be working, the safety edge seems to be working too. However when I try to run the auto set it just says KO, the manual doesn't explain what can cause this bar to check the hardware. Anyone might be able to start me off on what to look for?
Thanks!
James
I was wondering if anyone would be able to help me troubleshoot my gate.
I have a Telescopic gate with a BFT Leo controller, bircher safety edges (RF2.2), and BFT photocells. The gate recently stopped working and was reset. I have checked all the photocells and they seem to be working, the safety edge seems to be working too. However when I try to run the auto set it just says KO, the manual doesn't explain what can cause this bar to check the hardware. Anyone might be able to start me off on what to look for?
Thanks!
James