Came ZA3 Control panel wiring help and setting up help

[BarkerandGeary]

first of all how many pairs of photocell are you connecting?

I'll presume the bare minimum of 1 set.

photocell >>>>> ZA3 panel

+ >>>>>>>>>>>>>>>10
->>>>>>>>>>>>>>>11
com>>>>>>>>>>>>>>> 2
n/c >>>>>>>>>>>>>>> c1

dip switches on doc e cells
1 - off(down) 1 pair of photocells
2 - off(down) 24v system

dip switches on za3 panel
1-on
2-off
3-off
4-off
5-off
6-off
7-off
8-on
9-off

make sure you have a link between 1 and 2 in the za3 this is the stop circuit.

trimmers in za3

tl roughly about 6 o'clock needs to make the motors run for an extra 8 or so seconds after fully opening or closing.
tca somewhere near 5 o'clock will give you about 35 seconds opening waiting period.
rt2m this is the second leaf delay so if you have a catchment strip you need to adjust this accordingly.there is a minimum 2nd leaf delay of 1 second in this panel.


If the wrong motor moves first swap the 2 bunches of motor leads over
u,v,w into x,w,y

if one of the motors moves in a different direction to the other swap either u ,v or x,y over depending on which motor it is.

regards Johnathan Barker