Thread Rating:
  • 2 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EDSWG
#1
Hi, I have a Nice Filo automated sliding gate and a Nice EDSWG keypad, no matter following the instructions for the motor or keypad I seem unable to link the two.
Any advice appreciated!
Thanks
Reply
#2
(07-08-2021, 12:48 PM)ianmonro Wrote: Hi, I have a Nice Filo automated sliding gate and a Nice EDSWG keypad, no matter following the instructions for the motor or keypad I seem unable to link the two.
Any advice appreciated!
Thanks

Hi Ian,

Could you take me through the programming procedure you are doing?

Regards
Mike
Reply
#3
(09-08-2021, 08:59 AM)Michael Wrote:
(07-08-2021, 12:48 PM)ianmonro Wrote: Hi, I have a Nice Filo automated sliding gate and a Nice EDSWG keypad, no matter following the instructions for the motor or keypad I seem unable to link the two.
Any advice appreciated!
Thanks

Hi Ian,

The EDSWG is not compatible with the filo unless you have a standalone OXI receiver wired in. The compatible keypad is the DS100 as seen in the link below.

https://www.easygates.co.uk/product/nicehome-ds100/

Regards
Mike
Reply
#4
Ah ok, I understood it was compatible, looks as if I have a spare keypad!
Thanks for that,

Much appreciated
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)