House WG2 Gates will not close

[mousetarget]

Hi,

Please try factory resetting the control board, but pressing and holding P2 and P3 for around 10 seconds.

Once this is done, disconnect all accessories until it is just the motors wired in.

Then relearn the ECSBUS, press and hold P2 for 2-3 seconds.

Once that is done, manually release the gates into the halfway position and relearn the limits. (press and hold p3 until the gates being to move).

Once this is done, give it an open command via either the remote or bridging between the open input.

Any problems, give us a call on 01384 569942

Hope this helps.

Thanks so much for this good advice - I’ve done all this but can’t manually release my left gate as the mechanism wasn’t correctly put back after changing a part last year. So I can’t place both gates in the halfway position for the control board to relearn.

Is there anyway for me to manually release this gate with a strategically placed screwdriver etc?

Many thanks