Thread Rating:
  • 92 Vote(s) - 2.74 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Opening Delay
I have a CAME ZA4 controller and recently the delay between the left gate and right gate opening has disappeared i.e. both gates attempt to open at the same time - one pushes against the other triggering an automated cancellation of the open, and both gates close. 
Previously one gate used to open a couple of seconds before the other.

The technical manual talks about the 'TR2M' for "Trimmer delay on closing cycle motor n°2 adjustment".

I've played around with this adjustment and indeed it does change the delay between left and right gates on closing, but it seems to have no effect on the delay between the gates on opening.

Is there another adjustment which applies to opening?

Thanks in advance.

how old is this set ?
i think is worth to swap capacitors for new one .
Best Regards 

Possibly Related Threads...
Thread Author Replies Views Last Post
  CAME ZA3 Not opening & red light (program) flashing RandC 1 156 18-03-2019, 10:33 AM
Last Post: SamA
  Came ZM3E and Frog Motors both opening on M1 not seperately giuseppem 1 2,537 11-04-2018, 07:25 AM
Last Post: Automatic-TC
  Came sliding gate sticking on opening Jellybean 0 3,072 02-07-2016, 06:53 PM
Last Post: Jellybean
  Came gate opening adjustments TobagoGate 0 8,496 20-12-2012, 02:40 PM
Last Post: TobagoGate
  s-l-o-w opening, can speed be adjusted johnny 0 5,179 09-06-2010, 06:03 PM
Last Post: johnny

Forum Jump:

Users browsing this thread: 1 Guest(s)