Thread Rating:
  • 308 Vote(s) - 3.01 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Proteco Q60A circuit board
#1
I had an incident where the exterior aerial cable was pulled out of the control box cable gland and also pulled the terminal block off the circuit board.

[Image: q60a-1.jpg]

I am pretty sure I can solder the aerial back onto the board, as there are still copper prongs sticking up, from where the TB was.

However laying loose in the bottom of control box is a small device labelled as T6.6122

[Image: q60a-2.jpg]

Any idea what it this is. Is it part of the TBlock?
Reply
#2
The part you are referring to is the crystal of the pll receiver.
Location upper left corner of the board. It is connected to a smaller board that is the radio signal receiver
Reply
#3
Without traveling a few miles to have a look. Does it just clip into the RF board, or has it been ripped off its soldered lugs ?

Or does it mean a new board ?
Reply
#4
i will post some photos later in the afternoon.
Cheers
Reply
#5
    check out the location of the radio board and the crystal.
Reply
#6
Thanks for that. Do you reckon the crystal is clip in ?
Reply
#7
No the crystal is soldered in the board
Reply
#8
Thanks - It looks like a gamble then, I will give it a try and solder it back in place, and see what happens.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  q60a stevea 1 303 23-08-2024, 12:14 PM
Last Post: stevea
  Fried control board nickfr 3 1,414 22-03-2024, 12:53 PM
Last Post: JoeF
  BFT key pad not communication with digital board niall.paul@yahoo.co.uk 1 987 14-02-2024, 12:21 PM
Last Post: Michael
  Faac 452 pcb board benner91 2 2,718 09-02-2024, 06:13 PM
Last Post: benner91
  TC fault code on Q60ar control board Skydive1710 3 4,809 20-11-2023, 03:12 PM
Last Post: NormanY
  Proteco Advantage (Q60A) Error Code "03" CLAUDIOTX 3 19,109 26-09-2023, 05:32 AM
Last Post: max666
Exclamation Proteco Q60A stopped working xCO 0 1,321 19-06-2023, 01:03 PM
Last Post: xCO
  Replacement Q60A board? ndyhzlwd 1 2,642 10-02-2023, 03:19 PM
Last Post: SamA
  Nice Robus RB100 - Control Board Buttons Not Working sl991 5 5,455 02-12-2022, 02:51 PM
Last Post: JoeF
  Beninca bob motor wiring to board Ranch2 6 6,178 18-11-2022, 09:59 AM
Last Post: SamA

Forum Jump:


Users browsing this thread: 1 Guest(s)