Thread Rating:
  • 15 Vote(s) - 3.4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FAAC problem
#1
I have a newer FAAC control box, and using 400 series 220v actuators. when i activate the dual gates, they both open about 20% and then they close and the motors keep running. I do not have any safety features, no photo sensors , no other options or accessorizes .
I have tried the learning process and nothing seems to correct this. There is no binding or obstructions on the gates, i even unhooked them and tried to run the actuators unattached. 
I hooked up the actuators to my test bench switch and they both work perfectly. 
they are set at maximum torque. any suggestions?
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Faac 740D, Open further then limit, not closing emiel 1 633 26-08-2025, 02:23 PM
Last Post: Jakedugmore
  FAAC Eq45s , only Leaf A closing with remote Cummil2 1 2,813 13-03-2025, 10:06 AM
Last Post: benbrooks
  FAAC Eq45s , only Leaf A closing with remote Cummil2 1 2,612 13-03-2025, 10:05 AM
Last Post: benbrooks
  FAAC S800 Single swing Gate not responding robhight 0 2,775 18-11-2024, 11:48 AM
Last Post: robhight
  FAAC Configure 443Hz remote to open partially, pause and close Ezylryb 1 2,703 12-08-2024, 03:52 PM
Last Post: Jakedugmore
  Intermittent ‘Stop’ command - FAAC 741 Sliding Gate bwel 3 7,230 22-04-2024, 03:21 PM
Last Post: JoeF
  Faac 415 can't reset from manual to operate mode Stephen Q 1 5,640 18-03-2024, 01:20 PM
Last Post: RXH
  Faac 455d Grantplant 1 6,607 13-11-2023, 11:58 AM
Last Post: Aiden Mitton
  FAAC 740 limited travel LoneStarCycler 0 5,440 24-06-2023, 01:06 AM
Last Post: LoneStarCycler
  FAAC 400 cbac LN 104202 obey gates 1 10,805 21-11-2022, 09:54 AM
Last Post: SamA

Forum Jump:


Users browsing this thread: 1 Guest(s)