Thread Rating:
  • 201 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FAAC 740 - help needed!
#1
Hi,

My FAAC 740 was working fine yesterday, but today it stop working.

If I put it on manual mode, open the gate and then put it on automatic mode then it closes the gate. But that is the only action that it performs. After it is closed it doesn't do anything.

I checked the display to see the status and it stays in 02 status when it is closed.

Does anyone had a similar issue?

thanks in advance
Norberto
Reply


Messages In This Thread
FAAC 740 - help needed! - by norberto - 19-10-2016, 07:06 PM
RE: FAAC 740 - help needed! - by norberto - 10-11-2016, 06:25 PM
RE: FAAC 740 - help needed! - by Automatic-TC - 11-12-2016, 10:45 AM
RE: FAAC 740 - help needed! - by norberto - 12-12-2016, 12:23 AM
RE: FAAC 740 - help needed! - by Automatic-TC - 12-12-2016, 08:14 AM
RE: FAAC 740 - help needed! - by norberto - 12-12-2016, 10:43 AM
RE: FAAC 740 - help needed! - by Automatic-TC - 12-12-2016, 06:44 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Help needed sourcing manual release key - Chamberlain HC300 pb3000 0 85 30-07-2025, 07:41 AM
Last Post: pb3000
  FAAc xp20d wiring Neil Young 4 3,168 04-02-2025, 12:08 PM
Last Post: Neil Young
  FAAC gates out of sync TheDock 1 2,184 21-08-2024, 12:21 PM
Last Post: TheDock
  Faac 452 pcb board benner91 2 5,028 09-02-2024, 06:13 PM
Last Post: benner91
  Faac photocell stopped working Zeb Gulickx 2 5,695 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  FAAC E124 fault 05 allan@amtas.com.au 0 2,566 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 7,546 03-07-2023, 08:54 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 3,152 23-06-2023, 03:19 PM
Last Post: Alpin
  FAAC Photocells mmc1977 3 6,214 02-05-2023, 12:37 PM
Last Post: Matt Turner
  water damage to FAAC photocell Rajab 4 7,363 18-07-2022, 09:00 AM
Last Post: Michael

Forum Jump:


Users browsing this thread: 1 Guest(s)