Nice RB400

[benbrooks]

The Error codes are available in the manual, these are posted online by NICE Automation and Easygates. Nice have to deal with a lot of stupid questions, some of the technical department are a little short when it comes to Joe Public, I have had a few run ins with them- correcting them on their own equipment. Unfortunately their board design is approached differently when compared to other Manufacturers, they assume you will use the bluebus photocells and then shove everything into the configurable stop input.
It might be an idea to go back to a basic configuration for TESTING ONLY, turn off the power, remove the bluebus and stop plugs, turn it back on, carry out a bluebus relearn (can't remember for sure but i think it's the stop and open button together for 5 seconds on the panel, it's in the manual. If the gate works, you have a failed safety, plug in the stop and carry out another relearn, this will determine which safety has failed. (the stop led should always be illuminated for a N/C circuit).

Hi,

Just to add onto this and hopefully clarify.

Stop and Open held together until the LED's L1 and L2 start flashing is your bluebus search.

Stop and Close held together until the motor starts moving is your position search/calibration.

Open and Close held together for 10 seconds is a complete reset and wipes all memory and configurations from the panel.

Many thanks 
Ben