08-07-2025, 10:32 AM
The reed switch is the electronic stop control for the board. I thought the Robus motors had finger switches, but not ruling it out. unplug the reed switches from the board and check them with a multimeter on ohms, both swiitches should be N/C when the gate is midway, ohm meter should read around 2-4ohms? then test again with the magnets next to the reed switch it should read OL on you meter, basically open circuit. Should be 3 wires, they share the GND/common.
I've known NICE boards to fail on the limit switch circuit, this required a new board, FAAC reed switches have a terrible reliability issue, Nice not so much.
D
I've known NICE boards to fail on the limit switch circuit, this required a new board, FAAC reed switches have a terrible reliability issue, Nice not so much.
D