Thread Rating:
  • 12 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gate stuck after opening.
#5
(22-03-2024, 01:01 PM)rixman Wrote: Hey, there are no photocells it seems, It is just one gate: [Image: gate.jpg]

Hi,

Thanks for the message.

it could possibly be a short circuit on the command input which intern will hold the gates open until the short is rectified.

Joe
EasyGates.co.uk - EasyGates Ltd
 
EasyGates Direct - Trade only accounts.

Smart and Secure Center - Smart Home Products
Reply


Messages In This Thread
Gate stuck after opening. - by rixman - 16-03-2024, 10:19 PM
RE: Gate stuck after opening. - by rixman - 18-03-2024, 08:11 AM
RE: Gate stuck after opening. - by Michael - 20-03-2024, 10:38 AM
RE: Gate stuck after opening. - by rixman - 22-03-2024, 01:01 PM
RE: Gate stuck after opening. - by JoeF - 11-04-2024, 08:10 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  MC800 NOT OPENING FOR WHITELISTED PLATES AFTER FACTORY RESET Wenzo 4 868 27-05-2025, 09:09 AM
Last Post: benbrooks
  NICE gates open slightly then stuck Overthefence 2 898 21-05-2025, 10:54 AM
Last Post: Jakedugmore
  Looking for help with oldschool NICE gate motor gatekeeper 0 1,901 16-02-2025, 05:16 PM
Last Post: gatekeeper
  Nice RB600 - Automatic close fail and opening issues P100D 6 5,826 10-12-2024, 11:29 AM
Last Post: P100D
  BFT Gate Motor CDG 1 2,266 11-06-2024, 09:09 AM
Last Post: JoeF
  Nice MCA1 stuck open after stop command Khooke 1 4,762 25-09-2023, 10:47 AM
Last Post: Michael
  Replace receiver nice gate Mebeaker 2 8,467 29-03-2021, 03:42 PM
Last Post: Mebeaker
  wifi gate opener xjust 0 4,708 13-02-2021, 10:42 PM
Last Post: xjust
  Wifi Gate Opener - IT4WIFI problems Mehullakhani 0 8,089 12-08-2020, 11:10 AM
Last Post: Mehullakhani
  Aria gate openers and GSM controller Jamie 2 8,699 25-04-2020, 06:19 PM
Last Post: Jamie

Forum Jump:


Users browsing this thread: 1 Guest(s)