Yesterday, 08:28 PM
(This post was last modified: Yesterday, 09:05 PM by Shropshire_Lad.)
Hi,
Can anyone advise what cable I need to run from the control unit to the motor. It seems to say in the instructions 4 x 1.5mm for the power, 3 x 0.5mm for the encoder and 2 x 1mm for the Photocell Transmitter.
I understand the cable for the Photocell, but does the arm really need 2 separate cables, or can it be a single 7 core cable?
Can anyone advise what cable I need to run from the control unit to the motor. It seems to say in the instructions 4 x 1.5mm for the power, 3 x 0.5mm for the encoder and 2 x 1mm for the Photocell Transmitter.
I understand the cable for the Photocell, but does the arm really need 2 separate cables, or can it be a single 7 core cable?