willows79
02-12-2015, 09:45 PM
I have recently installed a single wing SCS300 24v system (to replace an old 230v CB1 board system).
Is there any way to introduce a short delay before the gate starts to open or close? My old CB1 system used to flash couple of times before the gate started moving to give people nearby a warning. Is this possible on the 24v system?
Thank you
Chris
Is there any way to introduce a short delay before the gate starts to open or close? My old CB1 system used to flash couple of times before the gate started moving to give people nearby a warning. Is this possible on the 24v system?
Thank you
Chris