E145s - error code 5 during setup

[pete.23]

Hi

I wonder if anyone can advise please, as I have spend a good few hours on this to no avail so far!

I have the latest E145s board setup with BUS safecoders, photocells and also 770N motors (leaf opening). Everything seems to light up and looks fine (all lights where they should be etc), the gates also run fine in manual mode. 

However, when I try and run the Timelearning setup (FAAC E145 manual section 5.4), I come out with an error code before anything takes place. See video link of scroll through and error

If anymore information is needed, let me know and I can provide - need to get this working ASAP!

Thanks

Pete

[colino]

Hi Pete,

Did you get a solution to this, I have the same problem and am hoping you can dig me out.

Colin


Hi

I wonder if anyone can advise please, as I have spend a good few hours on this to no avail so far!

I have the latest E145s board setup with BUS safecoders, photocells and also 770N motors (leaf opening). Everything seems to light up and looks fine (all lights where they should be etc), the gates also run fine in manual mode. 

However, when I try and run the Timelearning setup (FAAC E145 manual section 5.4), I come out with an error code before anything takes place. See video link of scroll through and error

If anymore information is needed, let me know and I can provide - need to get this working ASAP!

Thanks

Pete

[SamA]

Hi Pete,

Did you get a solution to this, I have the same problem and am hoping you can dig me out.

Colin


Hi

I wonder if anyone can advise please, as I have spend a good few hours on this to no avail so far!

I have the latest E145s board setup with BUS safecoders, photocells and also 770N motors (leaf opening). Everything seems to light up and looks fine (all lights where they should be etc), the gates also run fine in manual mode. 

However, when I try and run the Timelearning setup (FAAC E145 manual section 5.4), I come out with an error code before anything takes place. See video link of scroll through and error

If anymore information is needed, let me know and I can provide - need to get this working ASAP!

Thanks

Pete

Hi Guys,

This is not a fault I have seen before. I am currently conversing with Faac technical to get this resolved.

Sam.