Mhouse sl10 not closing

[Mark Reader]

Hi, I am wondering if anyone has any advise, my Mhouse sliding gate has developed an issue where it will only open. I can unlock it and move it to mid travel, using the remote or keypad it will only motor in the open direction, I can stop it but not reverse it, when it reaches the fully open pos’n the ecsbus lights repeatedly flashes 7times.
I’ve cleaned the board it looks ok(I think) 
Wondering if I need a new cl1s board but would like to exhaust other avenues first.
Cheers
Mark

[Michael]

Hi Mark,

This sounds like a photocell issue. What is the ECSBUS flashing light emitting (count the flashes followed by a pause).

Regards
Mike

[Sosislord]

I replaced the controller and it worked for a few months. Then the other day my wife was opening the gate and it stopped.
It is a CL1S controller. Is wont operate at all now. The ECS BUS and the P1 P2 and P3 lights are all flashing rapidly. I cleaned the  control board with IPA, though there was no obvious debris on it. When the gate is powered still has the flashing lights and no other operations.
Totally stumped with this

[Aiden Mitton]

I replaced the controller and it worked for a few months. Then the other day my wife was opening the gate and it stopped.
It is a CL1S controller. Is wont operate at all now. The ECS BUS and the P1 P2 and P3 lights are all flashing rapidly. I cleaned the  control board with IPA, though there was no obvious debris on it. When the gate is powered still has the flashing lights and no other operations.
Totally stumped with this

Hi,

The BLUEBUS led is a diagnostic LED, when this fault occurs (when the gate will not close upon command) check this LED and count the amount of flashes before there is a pause.

If you can let me know this, I may be able to inform you of what the issue may be.

Many Thanks,

Aiden.