Thread Rating:
  • 5 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Proteco Leader N1 problem
#1
Hello,
I have a Proteco Leader TI swing gate where motor was broken. After replacement, motor works for only a few seconds and then stops. Each time a start command is given, the same happens: motor runs for a few seconds and stops again. Fault notification on control board = N1. I have switched both swing gate motors to check whether it's motor related, but the problem remains: after switching, the other motor runs a few seconds and stops. Capacitor has been replaced as well; all wiring double checked since N1 is related to communication error between motor and control board??
Does anyone have suggestions?
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Photocell Problem marcoos_1 4 18,891 04-01-2024, 10:23 AM
Last Post: JoeF
  Proteco Advantage (Q60A) Error Code "03" CLAUDIOTX 3 17,854 26-09-2023, 05:32 AM
Last Post: max666
Exclamation Proteco Q60A stopped working xCO 0 940 19-06-2023, 01:03 PM
Last Post: xCO
  Proteco controller & ACT5e keypad - keeps tripping fclauson 4 3,847 26-08-2022, 03:42 PM
Last Post: JoeF
  Hello - Another Proteco Q60A/R Question! SawboMan 2 3,020 12-07-2022, 11:48 AM
Last Post: SamA
  Proteco Q60 - FH error then close after opening Needlerp 1 2,310 24-06-2022, 09:54 AM
Last Post: JamieF
  proteco q60a microcontroller program arashkhan 1 2,538 17-06-2022, 01:29 PM
Last Post: benbrooks
  Proteco Q60 AR ...Fob wont program Shane1 0 1,683 12-01-2022, 08:13 PM
Last Post: Shane1
  Master to slave remote problem Dingerb 0 1,570 24-12-2021, 01:26 PM
Last Post: Dingerb
  Proteco gates with photocell problem. Shane1 0 2,149 09-10-2021, 07:56 PM
Last Post: Shane1

Forum Jump:


Users browsing this thread: 1 Guest(s)