Thread Rating:
  • 7 Vote(s) - 3.71 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Beninca R1.6E - Photo Cell Issue
#1
Hi All

I do not normally use forums as most problems I can resolve however this one has stumped me and I do not have the appropriate wiring diagram.

Ten years ago I built and installed a sliding gate system using a Beninca R1.6E drive unit coupled with a Daitem intercom which has worked with no issues up until recently.

I now saw  that the photocell beam is not stopping the gate when broken Sad
I have checked the TX RX and the relay is clicking as it should but the signal does not stop the motor.

I wired this lot up ten years ago and do not have the wiring diagram, however to change the complete Beninca unit may be a bit extreme. I have checked all the terminal connections they are all fine with no corrosion.

Any thoughts would be welcome.


Attached Files Image(s)
   
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Beninca motors and Control unit sergomes 2 25,864 10-12-2016, 01:18 AM
Last Post: Automatic-TC
  Combined remote for Beninca/Cardale? londonthing 0 8,629 22-10-2016, 05:35 PM
Last Post: londonthing

Forum Jump:


Users browsing this thread: 1 Guest(s)