Thread Rating:
  • 5 Vote(s) - 2.4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MC824H with Toons - learning process
#1
Hi hope you can help.
Just installed this but at this stage have nothing connected other than the arm.
I go through the learning process, set the gate at half way point, it duly opens then closes, the opens again and stops. I expected it to close then it would have learned. I press open close buttons but nothing. I'm sure I must be making a simple mistake. I have dipswitch set for 4 for to5024, have also tried dipswitch 1. Appreciate any advice/help.
Once I have achieved this I will then add bluebus/remote, etc.
Thanks
Reply
#2
Hello,

All that is required is to change the polarity of the motor cables swapping the blue and brown cores. Complete the process again and the gate will end in the closed position.
Gate Automation and Access Control from EasyGates Retail Store

EasyGates Trade Store for Trade only

Smart Home Tech from The Smart and Secure Centre

Smart Home News from Smart Home Matters
Reply
#3
Worked a treat. You can also attach gate arm to a 18v power tool battery to test.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Nice photo sensor issue F210 and MC824H gates won’t operate Tantrum 1 1,518 04-01-2024, 10:06 AM
Last Post: Michael
  Mc824h hold open Simonizzy 2 16,748 20-07-2020, 10:00 AM
Last Post: RyanB
  Wiring photocell to MC824H davidja 2 13,836 14-04-2020, 02:17 PM
Last Post: davidja
  MC824H Simple Programming Guide easygates 2 21,277 25-03-2016, 09:43 PM
Last Post: Henwood_1988

Forum Jump:


Users browsing this thread: 1 Guest(s)