Thread Rating:
  • 225 Vote(s) - 2.76 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Daspi Programming
#1
When trying to program daspi esoft control board to work with the galaxy 550
swing arms, when i go into programming mode and i press the set button then the work button the arms start to open when i press the work button again to initiate slow down the arms do not respond and continue to open and the gates bang and jerk and open with the same force...
Reply
#2
Try again with SW1-2 and SW2-2 microswitches in the OFF position.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  BFT DEIMOS BT Programming issue dawoodejaz@hotmail.com 0 4,439 28-11-2019, 12:11 AM
Last Post: dawoodejaz@hotmail.com
  Help programming SUN 433 4CH remote jedimatafez 2 8,185 24-02-2019, 08:04 AM
Last Post: jedimatafez
  Programming remote Luke 1 8,161 16-05-2018, 07:38 PM
Last Post: Automatic-TC
  Roger Receiver programming Newuser 1 8,958 18-03-2013, 12:44 AM
Last Post: supermeske
  Tousek st 50 programming alban gates 1 10,028 20-10-2011, 11:22 AM
Last Post: Mark

Forum Jump:


Users browsing this thread: 1 Guest(s)