Thread Rating:
  • 269 Vote(s) - 2.76 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CB11 needs resetting
#1
Hi,

I recently installed a replacement lyn400 with a cb11 pcb. Every 2 - 3 days now the unit stops working. The only way to make it work is to switch off at the mains then restarts, after which it works fine for another couple of days. Any ideas?
Reply
#2
I need some more information as too what is installed ie photocells keyswitches push buttons etc etc


The reset can be achieved by having the gates in the close possition then insert the jumper marked save failsafe photocells. Turn off the power wait 20 seconds tunr the power back on wait 20seconds then remove the jumper and the board will now be reset and ready to operate
EasyGates Manuals - Directory of Manuals and Help Guides

Smart Home Matters - Smart Home News
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  CB11 Multiple Keypad support Pigsfoot 1 2,136 12-08-2022, 08:14 AM
Last Post: Michael
  Problem with delay time CB11 milan 2 10,801 04-10-2021, 01:44 AM
Last Post: DesmondVog
  LiftMaster SUB300M + CB11 fault jonesy1991 0 10,768 25-01-2016, 02:51 PM
Last Post: jonesy1991
  CB11 controller BrianP 2 13,769 16-09-2015, 08:58 AM
Last Post: Gateguy
  liftmaster CB11 hold gate open problem sparkey 5 29,985 13-05-2013, 08:17 AM
Last Post: brucekwilles
  Problem with CB11 Board Michael 1 11,518 08-05-2013, 11:32 AM
Last Post: Mark
  230v Lyn400 CB11 Board Capacitor req. redbluetwo 5 22,603 11-10-2011, 01:11 PM
Last Post: Mark
  CB11 control box Intercom release button not working Moreteyne 0 8,934 14-09-2011, 03:14 PM
Last Post: Moreteyne
  CB11 Programming Problem dwanee 1 11,870 19-04-2011, 03:59 PM
Last Post: Mark
  CB11 Fault ! stone acre 0 7,724 28-06-2010, 01:09 PM
Last Post: stone acre

Forum Jump:


Users browsing this thread: 1 Guest(s)