NIce Aria 400 unable to program gate open/close
|
NIce Aria 400 unable to program gate open/close
|
13-01-2020, 03:33 PM
Contacted Technical help at EasyGates and very helpful as usual. Since I only have one gate opener I was advised to wire motor into M2 terminals. Once I had done this all worked OK. The manual is not clear on this so I'd like to think it wasn't me!! There are a lot of errors in the manual so be warned, for example, on page 9 (English) fig 21 shows P1 key being pressed when I think it should be P3.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
NIce Aria 400 unable to program gate open/close - by Telboy - 12-01-2020, 01:06 PM
RE: NIce Aria 400 unable to program gate open/close - by Telboy - 13-01-2020, 03:25 PM
RE: NIce Aria 400 unable to program gate open/close - by Telboy - 13-01-2020, 03:33 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Gate stuck after opening. | rixman | 4 | 745 |
11-04-2024, 08:10 AM Last Post: JoeF |
|
| nice robus D400 smartphone control | YOSH | 1 | 867 |
05-03-2024, 04:45 PM Last Post: benbrooks |
|
| Nice MC800 Wiring issue | Adamzsite | 2 | 863 |
05-03-2024, 04:37 PM Last Post: Michael |
|
| nice robus troubleshooting | tarmongaidon | 7 | 16,762 |
30-01-2024, 05:19 PM Last Post: hasanova |
|
| Nice photo sensor issue F210 and MC824H gates won’t operate | Tantrum | 1 | 1,852 |
04-01-2024, 10:06 AM Last Post: Michael |
|
| Nice Robus RBA3c Wifi Relay Switch Wiring | denis | 1 | 2,325 |
01-11-2023, 09:45 AM Last Post: Michael |
|
| NICE MC800 Factory Reset | bg148 | 5 | 3,319 |
12-10-2023, 01:11 PM Last Post: JoeF |
|
| Nice MCA1 stuck open after stop command | Khooke | 1 | 2,606 |
25-09-2023, 10:47 AM Last Post: Michael |
|
| Problems with Aria 400 | RohitG | 1 | 2,256 |
17-03-2023, 09:47 AM Last Post: JoeF |
|
| Nice transmitters - compatibility | Noghar | 6 | 6,742 |
10-10-2022, 10:02 AM Last Post: benbrooks |
|
