Thread Rating:
  • 10 Vote(s) - 2.4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gate not closing
#1
Configuration: Double gate, remote control open gate input, exit open gate switch, intercom open gate contact, induction loop to open gate

After years of normal operation the gate was opened with a remote control and stayed open, refusing to close (it is programmed to close after 10 seconds or so). The photocells clicked OK. Eventually it *closed* after a car went over the induction loop and then operated normally from then on.

Does the controller maybe have a "keep gate open" functionality such as double press on the remote or press the remote for X seconds, which activates the keeping of the gate in an open position? (BTW, that would be a very useful function if it does not have it).

I tried powering the system off and on several times while the gate was open and refusing to close - no effect.
Reply


Messages In This Thread
Gate not closing - by JanHruska - 10-12-2019, 10:17 AM
RE: Gate not closing - by RyanB - 23-12-2019, 04:27 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Bft gate problem djkokalis 1 903 14-02-2024, 12:39 PM
Last Post: JoeF
  BFT Sliding Gate randomly opening and closing AdrianMate 1 607 14-02-2024, 12:18 PM
Last Post: Michael
  BFT Rigel 4 - single Gate Not Closing Tsnash 1 865 04-01-2024, 10:21 AM
Last Post: JoeF
  BFT sliding gate intermittent operation vozm100 5 1,812 02-10-2023, 09:08 AM
Last Post: Michael
  Set remote to “only open” gate mark123499 4 3,508 30-05-2023, 01:57 PM
Last Post: mark123499
Exclamation BfT Sub R - No Closing pressure 1 Leaf Bushpig 2 3,070 23-05-2023, 03:48 AM
Last Post: Bushpig
  BFT SubR not opening/closing sometimes Jimmyboy4 3 2,885 09-01-2023, 10:29 AM
Last Post: SamA
  Gates not fully closing stefen1978@hotmail.co.uk 2 2,659 10-10-2022, 10:07 AM
Last Post: Michael
  LUX G BT 2B not closing properly since manual override swinnie 1 2,028 03-08-2022, 01:44 PM
Last Post: JoeF
  Parallel (or not) gate motors Ian Evans 1 2,404 16-05-2022, 11:44 AM
Last Post: SamA

Forum Jump:


Users browsing this thread: 1 Guest(s)