Hi, I am hoping someone can point me in the right direction. I have a Rigel 4 with RE01 receiver. Worked fine for 15 years and now suddenly key fob will only work if I go within 1m of control box. So far I have tried;
1) Change key fob battery
2) Try 2nd fob
3) Change aerial (seemed the most likely source of the problem)
Still same problem - neither better nor worse.
I am reasonably knowledgeable about electronics - but not about these control units.
Where should I look next?
Receiver board? Can you even still get these REO1 boards?
The whole control / receiver board looks in great condition.
Any suggestions welcomed.
Many thanks,
Mike
1) Change key fob battery
2) Try 2nd fob
3) Change aerial (seemed the most likely source of the problem)
Still same problem - neither better nor worse.
I am reasonably knowledgeable about electronics - but not about these control units.
Where should I look next?
Receiver board? Can you even still get these REO1 boards?
The whole control / receiver board looks in great condition.
Any suggestions welcomed.
Many thanks,
Mike