Thread Rating:
  • 363 Vote(s) - 2.79 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Daitem SC902AU - Nice Toona 5 24V
#1
Hi,

I have a Daitem SC902AU and Nice Toona 5 24V gate motors (MC824H control unit) and am a little confused with the connection of the Daitem to open and close the gates.

In the Daitem manual it shows that you connect to terminal blocks 12 © and 14 (NO) not sure what the and NO is???

On the MC824H you have open and close terminals if I connect the Daitem to this the gate opens via the handset but does not close via the handset - Not sure what I'm missing???

Secondly, regarding manual setup via the MC824H. If I set all of the positions using the 8 LEDs the gates seem to ignore the max closed positions (0) and keep closing until they can't go any further and the same with the max open positions (they stop short of the positions I set). The way I read it (manual) I thought if you set these positions the gates would move to each of the settings?

Thanks in advance,

Dale
Reply


Messages In This Thread
Daitem SC902AU - Nice Toona 5 24V - by Foxster - 02-01-2013, 05:00 PM
RE: Daitem SC902AU - Nice Toona 5 24V - by Mark - 03-01-2013, 12:56 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  nice robus D400 smartphone control YOSH 1 518 05-03-2024, 04:45 PM
Last Post: benbrooks
  Nice MC800 Wiring issue Adamzsite 2 543 05-03-2024, 04:37 PM
Last Post: Michael
  nice robus troubleshooting tarmongaidon 7 16,099 30-01-2024, 05:19 PM
Last Post: hasanova
  Nice photo sensor issue F210 and MC824H gates won’t operate Tantrum 1 1,514 04-01-2024, 10:06 AM
Last Post: Michael
  Nice Robus RBA3c Wifi Relay Switch Wiring denis 1 1,998 01-11-2023, 09:45 AM
Last Post: Michael
  NICE MC800 Factory Reset bg148 5 2,873 12-10-2023, 01:11 PM
Last Post: JoeF
  Nice MCA1 stuck open after stop command Khooke 1 2,320 25-09-2023, 10:47 AM
Last Post: Michael
  Nice transmitters - compatibility Noghar 6 6,588 10-10-2022, 10:02 AM
Last Post: benbrooks
  NICE MC82H - connecting maglock grangerd 3 4,830 10-10-2022, 09:40 AM
Last Post: SamA
  Nice Robus Don't Auto Close!!!! Ali_1982 1 4,298 03-08-2022, 02:23 PM
Last Post: Michael

Forum Jump:


Users browsing this thread: 1 Guest(s)