Thread Rating:
  • 15 Vote(s) - 3.4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Getting motors working together
#1
Hi All
I am an electrician and recently replaced 2 Came linear rams to double gates, i think they are  the ATI-P   range and i believe its the ZA3-1 controller  (customer had bought the rams) the controller is existing. We also had to do some welding & alterations to the gates  and brackets

Nothing has been touched in the controller. They were set to open on activation of a remote control and close automatically  via the timer circuit. I cant get the gates to open and close together (one open , one closed etc) They both open the same way , i dont believe they are wired wrong.   I cant find any instructions on the rams, do they need setting up  before bolting to the gates  ( ie make sure both are fully out/in before powering up ?). It was late on Friday and we ran out of time. The welder bolted them up before i had a chance to check

thanks, Richard
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Faac photocell stopped working Zeb Gulickx 2 843 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  Rigel 5 - second keypad stopped working HarefieldHse 1 1,539 03-07-2023, 08:48 AM
Last Post: Michael
Exclamation Proteco Q60A stopped working xCO 0 940 19-06-2023, 01:03 PM
Last Post: xCO
  Underground aluminium motors and corrosion gatebotherer 1 1,338 02-06-2023, 08:21 AM
Last Post: JoeF
  Nice Robus RB100 - Control Board Buttons Not Working sl991 5 4,052 02-12-2022, 02:51 PM
Last Post: JoeF
  Wired up but not working Ranch2 7 4,543 18-11-2022, 10:02 AM
Last Post: SamA
  New underground motors doesn't pause Mahammad 1 2,123 03-05-2022, 10:05 AM
Last Post: Michael
  Faac 740 - stops working norberto 1 7,100 02-06-2020, 05:15 PM
Last Post: norberto
  Frog A gate motors granddadbaza 1 12,393 19-08-2019, 05:23 PM
Last Post: granddadbaza
  Daitem Wireless Intercom caller unit not working GemOpy 2 19,013 02-10-2017, 10:47 AM
Last Post: GemOpy

Forum Jump:


Users browsing this thread: 1 Guest(s)