Thread Rating:
  • 13 Vote(s) - 2.92 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Faac 740
#1
Hi there guys first time poster stumbled across your forum while troubleshooting.
Would appreciate some help if there's any going.

Installed above opener today all went well but having a bit of trouble.
Gate will not open or close.
On the logic side when gate is open I get correct PI(03),when gate is closed correct PI (00) however if I attempt to open gate logic changes to stopped (02) until it's pushed all way open at which point PI changes to open (03) then when I got to close,it does not change over to now closing(06) rather remains in open logic until it changes to close.
I have one set of closing photocells, open fsw has been shorted along with the stop and edge.

What's throwing me is the stop command where is it being generated from

Anywhone any help on this would be much appreciated
Reply
#2
All sorted
Reply
#3
Hi Mozil

It looks like I have the same problem that you had.

How did you manage to resolve?
Reply
#4
(07-09-2019, 08:33 PM)Mozil Wrote: Hi there guys first time poster stumbled across your forum while troubleshooting.
Would appreciate some help if there's any going.

Installed above opener today all went well but having a bit of trouble.
Gate will not open or close.
On the logic side when gate is open I get correct PI(03),when gate is closed correct PI (00) however if I attempt to open gate logic changes to stopped (02) until it's pushed all way open at which point PI changes to open (03) then when I got to close,it does not change over to now closing(06) rather remains in open logic until it changes to close.
I have one set of closing photocells, open fsw has been shorted along with the stop and edge.

What's throwing me is the stop command where is it being generated from

Anywhone any help on this would be much appreciated

Hi,  I am having the exact same issue, any chance you could post how you fixed it, thanks.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Faac 452 pcb board benner91 2 1,576 09-02-2024, 06:13 PM
Last Post: benner91
  Faac photocell stopped working Zeb Gulickx 2 835 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  FAAC E124 fault 05 allan@amtas.com.au 0 697 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 3,758 03-07-2023, 08:54 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 1,188 23-06-2023, 03:19 PM
Last Post: Alpin
  FAAC Photocells mmc1977 3 2,275 02-05-2023, 12:37 PM
Last Post: Matt Turner
  water damage to FAAC photocell Rajab 4 3,533 18-07-2022, 09:00 AM
Last Post: Michael
  455d FAAC FUSE IN CONTROL PANEL wildfig 0 2,068 04-10-2021, 02:34 PM
Last Post: wildfig
  FAAC foundation plate mun31 1 4,979 30-06-2021, 09:33 AM
Last Post: JamieF
  Older FAAC gate no power to circuit board tfb208 0 7,281 19-11-2020, 06:10 PM
Last Post: tfb208

Forum Jump:


Users browsing this thread: 1 Guest(s)