Thread Rating:
  • 7 Vote(s) - 2.71 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GIBIDI gate motor closing problem
#1
Hi,

I hope you can assist in diagnosing a problem which I have with my 2no. GIBIDI articulated arm 24v motors fixed to brick piers which operate a pair of metal gates with 2no. photocells. (As attached photos show).

On an increasingly frequent basis the gates fail to fully close leaving a gap of about 300mm between opening leaves.  When re-opening the gates they close OK........ until the next time the problem occurs!

Any assistance would be appreciated.

Regards

David.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Gibidi gate opener. Add a wired switch. Eagle_man 1 9,328 30-11-2021, 01:23 PM
Last Post: JamieF
  Beninca sliding gate. Rogeramjet 1 4,202 22-11-2021, 06:14 PM
Last Post: Asaded
  FAAC GATES NOT CLOSING Slick19000 0 3,217 21-07-2021, 01:45 PM
Last Post: Slick19000
  Problem with CB22 Larry 1 5,859 17-03-2021, 10:57 AM
Last Post: Michael
  Hello Looking for gate control help everettc4 1 6,420 05-02-2021, 01:12 PM
Last Post: JamieF
  Hi All BFT ALTAIR-P gates not closing michaelo76 0 5,125 13-08-2018, 05:47 PM
Last Post: michaelo76
  Inherited GiBiDi Gate Shuggy73 2 12,629 13-04-2018, 05:18 PM
Last Post: Shuggy73
Cool Hello :) Gate/Barrier Engineer MrDiagnostics 0 7,746 29-04-2017, 09:48 AM
Last Post: MrDiagnostics
  Mhouse Swing gate rmgsecurity Sri Lanka 0 6,978 12-11-2016, 03:00 AM
Last Post: rmgsecurity Sri Lanka
  BFT electric gate Er 35 Chantal 0 7,086 28-11-2015, 07:57 PM
Last Post: Chantal

Forum Jump:


Users browsing this thread: 1 Guest(s)