+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Remote Controls and Fobs (https://www.gateguide.co.uk/forumdisplay.php?fid=27)
+--- Forum: Programming and Cloning Help & Instructions (https://www.gateguide.co.uk/forumdisplay.php?fid=28)
+--- Thread: Nice mc424 problem (/showthread.php?tid=7206)
Nice mc424 problem - vitormiguel111 - 03-04-2024
Hello, I have a problem with my gate, i installed a nice mc42 plate everything is fine , but my gate opnes normaly, but when it closes it hits the stop and opens about 10 centimeters on its own , it always does this when closing, when opening it opens normally and stops. when i close it it reaches the end and opens by itself after insisting 3 times it cloeses completely, can anyone help me?i already erased the memory but i don´t have much pratice at this i think its just my bad configuration
RE: Nice mc424 problem - Michael - 09-04-2024
(03-04-2024, 09:48 PM)vitormiguel111 Wrote: Hello, I have a problem with my gate, i installed a nice mc42 plate everything is fine , but my gate opnes normaly, but when it closes it hits the stop and opens about 10 centimeters on its own , it always does this when closing, when opening it opens normally and stops. when i close it it reaches the end and opens by itself after insisting 3 times it cloeses completely, can anyone help me?i already erased the memory but i don´t have much pratice at this i think its just my bad configuration
Hi,
When the fault appears, what is the BLUEBUS led indicating? this is a diagnostic led, if you count the flashes before a brief pause and let me know.
Regards
Easygates Ltd