+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Gate Automation and Installation Help (https://www.gateguide.co.uk/forumdisplay.php?fid=1)
+--- Forum: Automatic Gates - Help and Support (https://www.gateguide.co.uk/forumdisplay.php?fid=20)
+--- Thread: Faac 740 (/showthread.php?tid=6531)
Faac 740 - Mozil - 07-09-2019
Hi there guys first time poster stumbled across your forum while troubleshooting.
Would appreciate some help if there's any going.
Installed above opener today all went well but having a bit of trouble.
Gate will not open or close.
On the logic side when gate is open I get correct PI(03),when gate is closed correct PI (00) however if I attempt to open gate logic changes to stopped (02) until it's pushed all way open at which point PI changes to open (03) then when I got to close,it does not change over to now closing(06) rather remains in open logic until it changes to close.
I have one set of closing photocells, open fsw has been shorted along with the stop and edge.
What's throwing me is the stop command where is it being generated from
Anywhone any help on this would be much appreciated
RE: Faac 740 - Mozil - 09-09-2019
All sorted
RE: Faac 740 - Trig - 05-04-2021
Hi Mozil
It looks like I have the same problem that you had.
How did you manage to resolve?
RE: Faac 740 - david@venusawards.co.uk - 13-06-2021
(07-09-2019, 08:33 PM)Mozil Wrote: Hi there guys first time poster stumbled across your forum while troubleshooting.
Would appreciate some help if there's any going.
Installed above opener today all went well but having a bit of trouble.
Gate will not open or close.
On the logic side when gate is open I get correct PI(03),when gate is closed correct PI (00) however if I attempt to open gate logic changes to stopped (02) until it's pushed all way open at which point PI changes to open (03) then when I got to close,it does not change over to now closing(06) rather remains in open logic until it changes to close.
I have one set of closing photocells, open fsw has been shorted along with the stop and edge.
What's throwing me is the stop command where is it being generated from
Anywhone any help on this would be much appreciated
Hi, I am having the exact same issue, any chance you could post how you fixed it, thanks.