I am replacing a lightening destroyed ZA3N with a ZA3P (couldn't get a ZA3N anymore). I am getting the Red programming LED flashing, but no action. I have shorted the movement sensors which did not help. Do I perhaps need to put some shorting links in the limit switch connector? I have dual gates with ATI motors. I have read the manual multiple times, but not getting anywhere. I would have expected a simple(!) panel swap to be straightforward.....
Any help gratefully received.
(29-07-2023, 09:45 AM)Bluefastcar Wrote: [ -> ]I am replacing a lightening destroyed ZA3N with a ZA3P (couldn't get a ZA3N anymore). I am getting the Red programming LED flashing, but no action. I have shorted the movement sensors which did not help. Do I perhaps need to put some shorting links in the limit switch connector? I have dual gates with ATI motors. I have read the manual multiple times, but not getting anywhere. I would have expected a simple(!) panel swap to be straightforward.....
Any help gratefully received.
Hi,
Thanks for the message.
I can see this message is from quite some time ago, was this matter resolved?
Joe